3/11/2021 0 Comments Ncr 7197 Setup
Connected the printer by USB and also by RS232 for direct printing but print doesnt come out.Install the printer edge port drivers.Note down the COM port in use by the printer.You can check by going to Device Manager and looking under COM Ports, the printer is listed as EPIC port (COMx).
![]() In unicenta, select epson as your printer, then file, then COM port which you found above. Go to the location where you downloaded the drivers and double click the file. All features, functions, and operations described herein may not be marketed by NCR in all parts of the world. Therefore, before using this document, consult with your NCR representative or NCR office for information that is applicable and current. Use of a cable other than described here will require that you test this cable with the NCR printer and your system for FCC and CE mark certification. However, there is no guarantee that interference to radio communications will not occur in a particular commercial installation. If this equipment does cause interference, which can be determined by turning the equipment off and on, the user is encouraged to contact NCR immediately. For a complete listing of topics, consult the Table of Contents or the Index. The industry-standard RS-232C communication interface allows the 7197 to be connected to any host computer that uses RS-232C or USB communication interface. Receipt Station Thermal printing Standard pitch (host selectable): 15.2 characters per inch, 44 columns Compressed pitch (host selectable): 19.0 characters per inch, 56 columns. Ordering Thermal Receipt Paper The 7197 requires NCR qualified thermal paper to be used on the thermal receipt print station to insure proper operation of the printer. In addition the paper rolls must be have the following dimension. Use any household cleaner designed for plastics, but test it first on a small unseen area. If the receipt bucket is dirty, wipe it with a clean, damp cloth. Remove the printer from the foam pack and plastic bag. Remove the receipt paper roll and cables from the foam packing material. Choosing a Location The 7197 printer takes up relatively little counter space and may be set on or near the host computer. Make sure there is enough room to open the receipt cover to change the paper. Connecting the Cables There are three different types of cables that connect to the printer: Power supply cable supplying power from the power supply. Otherwise, the printer is off-line. For Host powered installation plug the DC cable into the POS terminal. March 2002. As such, neither the printer nor the host requires user configuration to work. Ncr 7197 Setup Serial Communication InterfaceHowever, since the NCR solution simulates a serial communication interface, you must configure handshaking on the printer for proper operation. Reset the printer. See below for information on resetting the printer. The printer beeps, prints the current configuration, then waits for you to make a selection from the Main Menu on the printout. Press the Paper Feed button quickly for a short click. Select Set Communication Interface from the Main Menu. Click on the file you downloaded and follow the on-screen instructions.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |